The use of steel side boxes can greatly improve the image of the product, the company's image is greatly improved, the safety performance is more stable, and the integrity of customer receipt and inspection is guaranteed. So how is such a good product produced? Today I will introduce the production process of steel side boxes.

The production of wooden box boards: according to the required size, the wooden box bottom plate and wooden box square pillars (there are divided into particle piers and plywood square pillars, according to customer needs), wood Box feet, wooden box front and rear panels, wooden box left and right panels, wooden box cover. If the plywood is cut over 9mm, the cutting surface of the edge of the plywood should be at an angle of 45 degrees, so that the 90-degree angle steel strip of the plywood can better connect the two plywood.

Steel belt production: purchase a set of equipment that specializes in the production of wooden box steel belts, which can produce suitable steel belts according to the outer dimensions of the wooden box. Specifically, the size of the steel belt can be adjusted, and the buckle hole on each side of the steel belt According to the size of the wooden box, the width of the steel belt edge is produced. Generally, the unfolded width is 42.5 mm. It is used for wooden boxes with a length and width of 1.2 meters or more. The unfolded width is 36 mm. Wooden box. A steel belt with a round hole directly on the steel belt does not need a buckle tongue. It is used on a wooden box and cannot be disassembled.

The assembly of the steel side box: first press the steel belt with a press machine to press the steel belt on the bottom plate of the wooden box pallet, and then combine the square columns and feet on the bottom plate with iron nails to make a pallet, and then put the steel belt and buckle The tongues are pressed on the surrounding panels and cover plates with a press in turn, and are usually combined into a wooden box after being delivered to the site. A steel belt with a round hole directly on the steel belt does not need a buckle tongue. It is used on a wooden box and cannot be disassembled.